No support for 2GB or 4GB virtual cartridge type The RTD Buddy is the RTD that shares the same link. Specified subsystem name does not match the actual subsystem name of the secondary VTSS RTD port is not attached to a Clustered VTSS RTD port is connected to a Secondary VTSS and not a Real Tape Drive Warm start recovery for the specific request should be performed.
This reason code indicates that the VTCS detected an Interface Control Check (IFCC) during the ECAM-T request. Reserved for use by VTCS, not generated by the VTSS. RTD is online, configuration cannot be changed. Unable to service request - interface is configured in control unit mode. Interface is already assigned to another RTD. VTCS is doing cleanup after a VTSS warm boot. RLINK is offline_fail, offline_pending or online_pending.
RTD, CLINK, RLINK is offline or inoperable. VTV exists - VTV is in buffer but not in CDS. Prerequisite value not equal to value in subsystemĪ Cache Reinit has interrupted the operation and caused it to fail. Replication failed because of insufficient resource on the secondary VTSS. Replication failed because of insufficient resource on the primary VTSS.
This parameter conflicts with another parameter. Multiple paths to an RTD report FCSN mismatch.īad data block detected by the primary VTSSīad data block detected by the secondary VTSSĮnhanced Synchronous Replication MIH value exceeded Synchronous Replicate failed due to a timeoutĪctual block ID does not match expected Block IDīlocks transferred (bytecnt) does not match mediasiz. For user response, see "CC5 RC117."ĭata check on lbl rec - VTV not determined. For user response, see "CC5 RC115."īad MVC position was specified. For user response, see "CC5 RC114."Įnd-of-Tape encountered. Warning: Could be a bad recall from an MVC! Request accepted for asynchronous process Head over to the JD Squared Channel on YouTube for examples of operating SheetCam.Table 7-1 ECAM Completion Codes, Return Codes, and Descriptions Completion Code
Install the SheetCam Machines DirectoryĬopy the SheetCam machine directory to the Documents directory. Install the mad_le fileĬopy and paste mad_le file to the Documents/mad_tools folder. The bundle currently contains a SheetCam Machines folder, and a mad_le file.
You can even install these files to a network share.
If you are comfortable with Windows, feel free to customize the directory structure as you see fit. The following file locations are recommended, and reflect how a machine is initially configured at the factory.